Base Custom Horizontal

With the Base Custom Horizontal cabinet, configurations add up horizontally. To choose more then 5 configurations, define the next section style with the drop-down menus of the Config tab.

The last section’s width takes the difference between Width (W) and other configurations.

In the example below: Width (W) – Section 1 Width (CFW1) - Section 2 Width (CFW2) - Section 3 Width (CFW3) = Section last Width

Hinging (HGC [CFGS]) is set independently for each configuration (even value is left, odd is right)

Variables to set in the Door and Drawer tab:

Pull Position Base (PPB)

 

Pull Position Drawer (PPDW)

 


The amount of drawers displayed horizontally is set with Drawer Quantity (NHD1).

 

In a case where there would be more than 1 drawer in a configuration, the first drawer would be the top one, and numeration would increase towards the bottom of the configuration.
Drawer Divider (DWDIV) sets the quantity of dividers between 2 drawers.
Drawer Case Depth (DWD1) determines drawer depth.

Variables to set in the Reveal tab:

Config Middle Reveal (CMC) [CFGS]
Door/dwr Horizontal Reveal (DDHC)

Other illustrated variables:

Vertical Partition Thickness (VPT [CFGS])
Shelf Depth (SD [CFGS])
Door Thickness (DT1)